1.
Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.

5.
Pick out the wrong statement pertaining to the design of a horizontal tube evaporator.

6.
A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of

7.
Pick out the wrong statement pertaining to the design of the bubble cap tray of a distillation column to give stable operation and even vapour distribution.

8.
A certain pressure vessel manufacturer avoids doing reinforcements calculations for openings by always providing a reinforcing pad extending upto double the diameter of the opening and of the same material and thickness as that of the shell wall. If area compensation is accepted as a code guideline, his approach leads to safe design

Read More Section(Process Equipment and Plant Design)

Each Section contains maximum 100 MCQs question on Process Equipment and Plant Design. To get more questions visit other sections.