21. For a parallel RLC network shown in below, the steady state output voltage V(t) for ω = 1 rad/sec is
22. In a 20 Vac series RC circuit, if 20 V is read across the resistor and 40 V is measured across the capacitor, the applied voltage is
23. Following four resistances are connected in parallel; the largest power is dissipated by
1. 2.4 Ω, 1 W
2. 5.1 Ω, 2 W
3. 10 Ω, 5 W
4. 22 Ω, 10 W
1. 2.4 Ω, 1 W
2. 5.1 Ω, 2 W
3. 10 Ω, 5 W
4. 22 Ω, 10 W
24. In graph shown in the figure, for the tree with branches b, d and f, the fundamental loop would include
25. The voltage division and the current division forms a
26. Find Z-parameter of a shunt element Z
27. In a three-phase delta-connected balanced load:
28. A network has 4 nodes and 3 independent loops. What is the number of branches in the network?
29. A network contains only an independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage will-
30. As the poles of a network shift away from the axis the response becomes
Read More Section(Network Theory and Analysis)
Each Section contains maximum 100 MCQs question on Network Theory and Analysis. To get more questions visit other sections.