101. Switches and relays should be shown in this position with no operating force or applied energy:
102. These types of pipes are generally connected with bell and spigot joints or flanged joints:
103. An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
104. Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
105. The ________ tool on the Dimension tool bar places the length of an arch on a drawing.
106. These are special installations of stone or concrete marking the locations of points accurately determined by precise surveying:
107. The Press-Pull tool will ________ the face of a solid model in the direction it faces.
108. In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
109. When designing a home for a client, one of the most important pre-design considerations that an architect needs to address is ________.
110. This is formed where three or more surfaces intersect:
Read More Section(Engineering Drawing)
Each Section contains maximum 100 MCQs question on Engineering Drawing. To get more questions visit other sections.