131. This is a line terminated by arrowheads, indicating the direction and extent of a dimension:
132. This type of weld is the most common in structural steel fabrication:
133. Acceptable parts must not extend beyond this:
134. In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
135. Center lines are used to locate or represent the centers of ________.
136. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct iso-plane has been selected by scrolling through the iso-planes using the ________ key.
137. Approximately this much of the cost of product development and manufacture is determined at the design stage:
138. If a plane is parallel to the plane of projection, it appears:
139. An accurate record of changes made to release drawings is tracked via this:
140. The site plan illustrates _________.
Read More Section(Engineering Drawing)
Each Section contains maximum 100 MCQs question on Engineering Drawing. To get more questions visit other sections.