Manufacturing And Production Technology MCQ Questions & Answers | Mechanical Engineering

A. Feed marks or ridges left by the cutting tool

B. Fragment of built-up edge on the machined surface

C. Cutting tool vibrations

D. All of these

A. By a form tool

B. By setting over the tail stock

C. By a taper turning attachment

D. By swiveling the compound rest

A. By a form tool

B. By setting over the tail stock

C. By a taper turning attachment

D. By swiveling the compound rest

A. Occurs at the middle

B. May not occur at the middle

C. Depends upon the material of the tool

D. Depends upon the geometry of the tool

A. Gas metal arc welding

B. Submerged arc welding

C. Gas tungsten arc welding

D. Flux coated arc welding

A. Ceramic

B. Stellite

C. Diamond

D. Cemented carbide

A. A set of grid points on the surface

B. A set of grid control points

C. Four bounding curves defining the surface

D. Two bounding curves and a set of grid control points

A. Nose part, front relief face and side relief face of the cutting tool

B. Face of the cutting tool at a short distance from the cutting edge only

C. Cutting edge only

D. Front face only

A. Nose part, front relief face and side relief face of the cutting tool

B. Face of the cutting tool at a short distance from the cutting edge

C. Cutting edge only

D. Front face only

A. High speed steel

B. Carbon steel

C. Wrought iron

D. All of these