51. The maximum stress produced in a bar of tapering section is at
52. Diamond riveted joint can be adopted in the case of following type of joint
53. In the below figure, the point E represents.
54. In a riveted joint, when the number of rivets decreases from the inner most row to outer most row, the joint is said to be
55. In a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be
56. The ratio of shear modulus to the modulus of elasticity for a Poisson's ratio of 0.4 will be
57. The maximum deflection of a cantilever beam of length '$$l$$' with a uniformly distributed load of 'w' per unit length is (where W = w$$l$$)
58. The shear force diagram of a cantilever beam of length ‘l’ and carrying a uniformly distributed load of w per unit length will be
59. If the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is
60. A circular shaft fixed at, A has diameter D for half of its length and diameter D/2 over the other half, as shown in the below figure. If the rotation of B relative to A is 0.1 radian, the rotation of C relative to B will be
Read More Section(Strength of Materials in ME)
Each Section contains maximum 100 MCQs question on Strength of Materials in ME. To get more questions visit other sections.