Introduction to Mining Engineering MCQs Questions & Answers | Mining Engineering

A. P-4,Q-2, R-3, S-1

B. P-3, Q-4, R-2, S-1

C. P-2, Q-3, R-4, S-1

D. P-2, Q-4, R-3, S-1

A. 15

B. 25

C. 30

D. 150

A. Physical

B. Mechanical

C. Bacterial

D. Physico-electrical

A. X > Y > Z

B. Y > X > Z

C. Y > Z > X

D. X > Z > Y

A. The vertical line at the panel edge and line connecting the panel edge and zero subsidence on the surface

B. The vertical line at the panel edge and line connecting the panel edge and point of critical deformation on the surface

C. The vertical line at the panel edge and line connecting the panel edge and point of the maximum tensile strain on the surface

D. The horizontal line and the line connecting the panel edge and zero subsidence on the surface

A. Wider gallery

B. Narrow gallery

C. Staggered gallery

D. Blasting gallery

A. Is above the geometric profile

B. Is below the geometric profile

C. Is on the geometric profile

D. There is no relation with the geometric profile

A. Shovel

B. Dozer

C. Dragline

D. Payloader

A. Cut-and-fill stoping, Sublevel caving, Sublevel open stoping, Block caving

B. Sublevel open stoping, Cut-and-fill stoping, Sublevel caving, Block caving

C. Sublevel caving, Sublevel open stoping, Cut-and-fill stoping, Block caving

D. Block caving, Sublevel caving, Sublevel open stoping, Cut-and-fill stoping

A. For quicker intercommunication

B. For easier pit top arrangement

C. Closer outlets will weaken the shaft pillar causing possibility of leakage

D. There may be possibility of subsidence