A claming section before the liquid flows into the downcomer is privided to
A. Permit release of entrained vapour in the liquid
B. Reduce the discharge fluctuation
C. Ensure better vapour-liquid contact
D. Cool the liquid before it flows down
Answer: Option A
This Question Belongs to Chemical Engineering >> Process Equipment And Plant Design
Related Questions on Process Equipment and Plant Design
Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.
A. $$\frac{1}{8}$$ and $$\frac{1}{{64}}$$
B. $$\frac{1}{{64}}$$ and $$\frac{1}{8}$$
C. $$\frac{1}{2}$$ and 8
D. $$\frac{1}{2}$$ and 5
A. Less than
B. 1.25-1.50 times
C. 2.5 times
D. One-fourth of
Value of Peclet number = 0, is the representative of
A. Laminar flow
B. Complete back mixing
C. Plug flow
D. Eddy diffusivity = 0
Join The Discussion