A switch has been configured for three different VLANs: VLAN2, VLAN3, and VLAN4. A router has been added to provide communication between the VLANs. What type of interface is necessary on the router if only one connection is to be made between the router and the switch?
A. 10Mbps Ethernet
B. 56Kbps Serial
C. 100Mbps Ethernet
D. 1Gbps Ethernet
Answer: Option C
Solution(By Examveda Team)
Although you can use either 100Mbps or 1Gbps Ethernet, the 100Mbps is necessary at a minimum and is the best answer to this question. You need to trunk the link from the switch to the router to make this connection work with inter-VLAN communication.This Question Belongs to Networking >> Virtual LANs
Which of the following is true regarding VLANs?
A. You must have at least two VLANs defined in every Cisco switched network.
B. All VLANs are configured at the fastest switch and, by default, propagate this information to all other switches.
C. You should not have more than 10 switches in the same VTP domain.
D. VTP is used to send VLAN information to switches in a configured VTP domain.
Which of the following is true regarding VTP?
A. All switches are VTP servers by default.
B. All switches are VTP transparent by default.
C. VTP is on by default with a domain name of Cisco on all Cisco switches.
D. All switches are VTP clients by default.
Which of the following commands sets a trunk port on a 2960 switch?
A. trunk on
B. trunk all
C. switchport trunk on
D. switchport mode trunk
Join The Discussion