After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
A. MEM /P
B. MEMMAKER
C. MEM /C
D. SYS:
E. None of the above
Answer: Option D
Related Questions on Computer Hardware
From what location are the 1st computer instructions available on boot up?
A. ROM BIOS
B. CPU
C. boot.ini
D. CONFIG.SYS
E. None of the above
What could cause a fixed disk error.
A. No-CD installed
B. bad ram
C. slow processor
D. Incorrect CMOS settings
E. None of the above
Missing slot covers on a computer can cause?
A. over heat
B. power surges
C. EMI.
D. incomplete path for ESD
E. None of the above
When installing PCI NICS you can check the IRQ availability by looking at
A. Dip switches
B. CONFIG.SYS
C. Jumper settings
D. Motherboard BIOS
E. None of the above
Join The Discussion