For welding plates of thickness less than 5 mm, its edges
A. Do not require bevelling
B. Should be bevelled to a single-V or U-groove
C. Should have a double-V or U-groove on one side
D. Should have a double-V or U-groove on both sides
Answer: Option A
Solution(By Examveda Team)
The purpose of providing a bevel or any other joint preparation is to make provision for good metal penetration into the joint.A square butt weld will be done up to 5 mm thickness and over 5 mm upto 16 mm single-v joint will done with a root gap of 3 mm and root face height of 3 - 4 mm. Over 20 mm double-v or single-U is selected.
Related Questions on Workshop Technology
The brass and bronze are welded by _________ flame.
A. Neutral
B. Oxidizing
C. Carburising
D. All of these
In TIG arc welding, the welding zone is shielded by an atmosphere of
A. Helium gas
B. Argon gas
C. Either (A) or (B)
D. None of these
In sheet metal blanking, shear is provided on punches and dies so that
A. Press load is reduced
B. Good cut edge is obtained
C. Warping of sheet is minimized
D. Cut blanks is straight
Join The Discussion