In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that
A. The effect of curvature of the cylinder wall is neglected
B. The tensile stresses are uniformly distributed over the section of the walls
C. The effect of the restraining action of the heads at the end of the pressure vessel is neglected
D. All of the above
Answer: Option D
A cotter joint is used to connect two __________ rods.
A. Co-axial
B. Perpendicular
C. Parallel
D. None of these
The rated life of a bearing varies
A. Directly as load
B. Inversely as square of load
C. Inversely as cube of load
D. Inversely as fourth power of load
The bending stress in a curved beam is
A. Zero at the centroidal axis
B. Zero at the point other than centroidal axis
C. Maximum at the neutral axis
D. None of these
The centre to centre distance between two consecutive rivets in a row, is called
A. Margin
B. Pitch
C. Back pitch
D. Diagonal pitch
Join The Discussion