In piercing operation, the clearance is provided on
A. Punch
B. Die
C. Half on the punch and half on the die
D. Either on punch or die depending upon designer's choice
Answer: Option B
Solution(By Examveda Team)
Piercing is process in which punch operation cuts a hole/material by tearing operation from a final piece of sheet metal. Piercing is a blanking operation.In piercing operation, the clearance is provided on die.
This Question Belongs to Mechanical Engineering >> Workshop Technology
Join The Discussion
Comments ( 2 )
Related Questions on Workshop Technology
The brass and bronze are welded by _________ flame.
A. Neutral
B. Oxidizing
C. Carburising
D. All of these
In TIG arc welding, the welding zone is shielded by an atmosphere of
A. Helium gas
B. Argon gas
C. Either (A) or (B)
D. None of these
In sheet metal blanking, shear is provided on punches and dies so that
A. Press load is reduced
B. Good cut edge is obtained
C. Warping of sheet is minimized
D. Cut blanks is straight
the statement Piercing is a Blanking operration , is I think wrong. Piercing is opposite to blanking or similar to punching.
Correct ans. (A) punch