The main requirement of an ignition system is that the
A. Spark at the plug electrode must be regular and timed with respect to the cylinder piston position
B. Spark should be sufficiently strong so as to start ignition of the charge
C. System should function efficiently at the maximum and minimum speeds of the engine
D. All of the above
Answer: Option D
This Question Belongs to Automobile Engineering >> Ignition System
Spark plug gaps are required in the range of
A. 0.02 to 0.6 mm
B. 0.45 to 1.00 mm
C. 0.90 to 2.00 mm
D. 1.00 to 1.30 mm
A. It is the time for which the contact breaker points remain closed
B. It is the time for which the contact breaker points remain open
C. The time during which inlet and exhaust valves open
D. The time during which inlet and exhaust valves close
Preignition can be caused due to presence of . . . . . . . .
A. Excess lubricants in cylinder
B. Gum in fuel
C. Over-heated spark plug
D. Higher volume of air in air fuel mixture
A signal generator in transistorized ignition system consist of
A. Ignition coil, permanent magnet and electronic control unit
B. A signal rotor, permanent magnet and electronic control unit
C. A signal rotor, a pick up coil and electronic control unit
D. A signal rotor, a pick up coil and a permanent magnet
Join The Discussion