The simplest and most common method of reducing any effect of inductive coupling between measurement and power circuits is achieved by using
A. a screen around the entire measurement circuit
B. twisted pairs of cable
C. capacitor(s) to be connected at the power circuit
D. capacitor(s) to be connected at the measurement circuit
Answer: Option B
This Question Belongs to Electronics And Communications Engineering >> Measurement And Instrumentation
The spring material used in a spring control device should have the following property.
A. Should be nonmagnetic
B. Most be of low temperature coefficient
C. Should have low specific resistance
D. All of the above
Why is a MISC meter not recommended for DC measurement?
A. The meter is calibrated for AC and it’s error for DC would be high
B. The meter does not respond to DC signals
C. The error is high due to hysteresis effect
D. The error is high due to eddy current effect
A moving iron ammeter may be compensated for frequency errors by
A. A shunt resistance
B. A series inductance
C. Shunt capacitance
D. Series resistance
Join The Discussion