To install a second IDE drive into a computer, you must:
A. Set the master-slave jumper to slave on the second drive
B. Use the IDE configuration software to set the new drive as slave
C. Verify that you define the new drive as D: in the CMOS setup
D. Verify that you attach the drive to the connector at the end of the ribbon cable
E. None of the above
Answer: Option A
From what location are the 1st computer instructions available on boot up?
A. ROM BIOS
B. CPU
C. boot.ini
D. CONFIG.SYS
E. None of the above
What could cause a fixed disk error.
A. No-CD installed
B. bad ram
C. slow processor
D. Incorrect CMOS settings
E. None of the above
Missing slot covers on a computer can cause?
A. over heat
B. power surges
C. EMI.
D. incomplete path for ESD
E. None of the above
When installing PCI NICS you can check the IRQ availability by looking at
A. Dip switches
B. CONFIG.SYS
C. Jumper settings
D. Motherboard BIOS
E. None of the above
Join The Discussion