Which of the following commands connect access list 110 inbound to interface ethernet0?
A. Router(config)# ip access-group 110 in
B. Router(config)# ip access-list 110 in
C. Router(config-if)# ip access-group 110 in
D. Router(config-if)# ip access-list 110 in
Answer: Option C
Solution(By Examveda Team)
To place an access list on an interface, use theip access-group command in interface configuration mode. This Question Belongs to Networking >> Security
Which of the following is true regarding access lists applied to an interface?
A. You can place as many access lists as you want on any interface until you run out of memory.
B. You can apply only one access list on any interface.
C. One access list may be configured, per direction, for each layer 3 protocol configured on an interface.
D. You can apply two access lists to any interface.
Which command would you use to apply an access list to a router interface?
A. ip access-list 101 out
B. access-list ip 101 in
C. ip access-group 101 in
D. access-group ip 101 in
Which of the following is an example of a standard IP access list?
A. access-list 110 permit host 1.1.1.1
B. access-list 1 deny 172.16.10.1 0.0.0.0
C. access-list 1 permit 172.16.10.1 255.255.0.0
D. access-list standard 1.1.1.1
A. access-list 10 deny 192.168.160.0 255.255.224.0
B. access-list 10 deny 192.168.160.0 0.0.191.255
C. access-list 10 deny 192.168.160.0 0.0.31.255
D. access-list 10 deny 192.168.0.0 0.0.31.255
Join The Discussion