Which of the following statement describes the correct procedure to be implemented when the electrode gap of a platinum tipped electrode is out of specification?
A. The side electrode should be aligned by bending it with the screw driver or some other similar tool
B. Gap adjustment should be performed by striking the side electrode with a hammer
C. In cases where the gap is too narrow, adjustment should be performed by filing off a portion of the center electrode
D. The plug should be replaced
Answer: Option D
This Question Belongs to Automobile Engineering >> Ignition System
Spark plug gaps are required in the range of
A. 0.02 to 0.6 mm
B. 0.45 to 1.00 mm
C. 0.90 to 2.00 mm
D. 1.00 to 1.30 mm
A. It is the time for which the contact breaker points remain closed
B. It is the time for which the contact breaker points remain open
C. The time during which inlet and exhaust valves open
D. The time during which inlet and exhaust valves close
Preignition can be caused due to presence of . . . . . . . .
A. Excess lubricants in cylinder
B. Gum in fuel
C. Over-heated spark plug
D. Higher volume of air in air fuel mixture
A signal generator in transistorized ignition system consist of
A. Ignition coil, permanent magnet and electronic control unit
B. A signal rotor, permanent magnet and electronic control unit
C. A signal rotor, a pick up coil and electronic control unit
D. A signal rotor, a pick up coil and a permanent magnet
Join The Discussion