You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?
A. jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B. jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C. jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D. jumper properly, auto-detect in CMOS, regular format
E. jumper properly, partition, low level format, high level format
Answer: Option B
This Question Belongs to Computer Science >> Computer Hardware
From what location are the 1st computer instructions available on boot up?
A. ROM BIOS
B. CPU
C. boot.ini
D. CONFIG.SYS
E. None of the above
What could cause a fixed disk error.
A. No-CD installed
B. bad ram
C. slow processor
D. Incorrect CMOS settings
E. None of the above
Missing slot covers on a computer can cause?
A. over heat
B. power surges
C. EMI.
D. incomplete path for ESD
E. None of the above
When installing PCI NICS you can check the IRQ availability by looking at
A. Dip switches
B. CONFIG.SYS
C. Jumper settings
D. Motherboard BIOS
E. None of the above
Join The Discussion