You connect a host to a switch port, but the new host cannot log into the server that is plugged into the same switch. What could the problem be?
A. The router is not configured for the new host.
B. The VTP configuration on the switch is not updated for the new host.
C. The host has an invalid MAC address.
D. The switch port the host is connected to is not configured to the correct VLAN membership.
Answer: Option D
Solution(By Examveda Team)
This question is a little vague, but the best answer is that the VLAN membership for the port is not configured.Which of the following is true regarding VLANs?
A. You must have at least two VLANs defined in every Cisco switched network.
B. All VLANs are configured at the fastest switch and, by default, propagate this information to all other switches.
C. You should not have more than 10 switches in the same VTP domain.
D. VTP is used to send VLAN information to switches in a configured VTP domain.
Which of the following is true regarding VTP?
A. All switches are VTP servers by default.
B. All switches are VTP transparent by default.
C. VTP is on by default with a domain name of Cisco on all Cisco switches.
D. All switches are VTP clients by default.
Which of the following commands sets a trunk port on a 2960 switch?
A. trunk on
B. trunk all
C. switchport trunk on
D. switchport mode trunk
Join The Discussion