You have created a named access list called Blocksales. Which of the following is a valid command for applying this to packets trying to enter interface s0 of your router?
A. (config)# ip access-group 110 in
B. (config-if)# ip access-group 110 in
C. (config-if)# ip access-group Blocksales in
D. (config-if)# blocksales ip access-list in
Answer: Option C
Solution(By Examveda Team)
Using a named access list just replaces the number used when applying the list to the router's interface.ip access-group Blocksales in is correct. This Question Belongs to Networking >> Security
Join The Discussion
Comments ( 1 )
Which of the following is true regarding access lists applied to an interface?
A. You can place as many access lists as you want on any interface until you run out of memory.
B. You can apply only one access list on any interface.
C. One access list may be configured, per direction, for each layer 3 protocol configured on an interface.
D. You can apply two access lists to any interface.
Which command would you use to apply an access list to a router interface?
A. ip access-list 101 out
B. access-list ip 101 in
C. ip access-group 101 in
D. access-group ip 101 in
Which of the following is an example of a standard IP access list?
A. access-list 110 permit host 1.1.1.1
B. access-list 1 deny 172.16.10.1 0.0.0.0
C. access-list 1 permit 172.16.10.1 255.255.0.0
D. access-list standard 1.1.1.1
A. access-list 10 deny 192.168.160.0 255.255.224.0
B. access-list 10 deny 192.168.160.0 0.0.191.255
C. access-list 10 deny 192.168.160.0 0.0.31.255
D. access-list 10 deny 192.168.0.0 0.0.31.255
c