You want to create a standard access list that denies the subnet of the following host: 172.16.50.172/20. Which of the following would you start your list with?
A. access-list 10 deny 172.16.48.0 255.255.240.0
B. access-list 10 deny 172.16.0.0 0.0.255.255
C. access-list 10 deny 172.16.64.0 0.0.31.255
D. access-list 10 deny 172.16.48.0 0.0.15.255
Answer: Option D
Solution(By Examveda Team)
First, you must know that a /20 is 255.255.240.0, which is a block size of 16 in the third octet. Counting by 16s, this makes our subnet 48 in the third octet, and the wildcard for the third octet would be 15 since the wildcard is always one less than the block size.This Question Belongs to Networking >> Security
Which of the following is true regarding access lists applied to an interface?
A. You can place as many access lists as you want on any interface until you run out of memory.
B. You can apply only one access list on any interface.
C. One access list may be configured, per direction, for each layer 3 protocol configured on an interface.
D. You can apply two access lists to any interface.
Which command would you use to apply an access list to a router interface?
A. ip access-list 101 out
B. access-list ip 101 in
C. ip access-group 101 in
D. access-group ip 101 in
Which of the following is an example of a standard IP access list?
A. access-list 110 permit host 1.1.1.1
B. access-list 1 deny 172.16.10.1 0.0.0.0
C. access-list 1 permit 172.16.10.1 255.255.0.0
D. access-list standard 1.1.1.1
A. access-list 10 deny 192.168.160.0 255.255.224.0
B. access-list 10 deny 192.168.160.0 0.0.191.255
C. access-list 10 deny 192.168.160.0 0.0.31.255
D. access-list 10 deny 192.168.0.0 0.0.31.255
Join The Discussion