Your network is configured as shown in the exhibit. "Engineering! and Salesl have DHCP installed up them." All the servers are Windows 2000 Server computers that use TCP/IP as the only network protocol. The sales department uses one subnet and has servers named Salesl and Sales2. The engineering department uses another subnet and has servers named Engineeringl and Engineering2. Salesl and Engineeringl are configured to act as DHCP servers. The router that joins the two subnets is not RFC 1542 compliant and does not support DHCP/BOOTP relay. You want to allow Salesl and Engineeringl to support client computers on each other's subnets. What should you do?
A. Set the router option in the DHCP Scopes to 192.168.2.1 for Engineeringl and 192.168.1.1 for Salesl
B. On Engineering2 and Sales2, install Routing and Remote Access, and configure RIP as a routing protocol
C. On Engineering2 and Sales2, install and configure the DHCP Relay Agent service
D. Configure Engineering2 and Sales2 as DHCP servers without any scopes
E. None of above
Answer: Option C
A. Convert the disk to dynamic disk shut doWn and restart the server
B. Backup the data on the stripe volume and delete the stripe volume. Create a raidS volume on the four disks, restore the data to the new raid5 volume
C. Backup the data on the stripe volume and delete the stripe volume. Create a mirror volume, shut down and restart the server. Restore the data to new mirror volumes
D. Backup the data on the stripe volume and delete the stripe
E. None of above
A. Copy the Windows NT 4.0 Printer Drivers to the Net logon shared folders on all Windows NT Server 4.0 computers still configured as BDCs
B. Copy the Windows NT 4.0 printer drivers to the Net logon shared folder on the PDC emulator
C. Change the sharing options on the printer to install additional drivers for Windows NT 4.0 or Windows 2000
D. Copy the Windows NT 4.0 printer drivers to the WinntSystem32 pri liter sdri vers folder on the Windows 2000 print server
E. None of above
A. Configure the Terminal server to run in Remote Administration mode
B. Grant the IT department Full Control permission to the Remote Desktop Protocol (RDP) on the Terminal server
C. Add the members of the IT department to the Power Users group on the Terminal server
D. Use third-party software to enable remote control of users' sessions
E. None of above
A. From the group policy options from the contoso.local domains set the option not override
B. From the group policy options from the Michigan and Florida OU, set the option not override
C. Block the group policy inheritance for the contoso.local domain
D. Block the group policy inheritance for Michigan and Florida OU
E. None of above
Join The Discussion