1. The angle formed by the line joining the stub axle steering arm ball joints with the vertical, when this line slants forward at the top is called
2. Which of these falls under LMV (Light Motor Vehicle) category based on capacity?
3. Maximum combustion pressure in a car petrol engine is about
4. Tachometer in a vehicle measures
5. Two door and four door type automobiles are classified as
6. The oil pan in an engine may be made of
7. Compression rings are generally made of
8. Exhaust valve face angle is generally
9. Which of the following is not a part of the chassis?
10. The primary purpose of a ring expander is to
Read More Section(Introduction of Automobile)
Each Section contains maximum 100 MCQs question on Introduction of Automobile. To get more questions visit other sections.