Compressors, Gas Turbines And Jet Engines MCQ Questions & Answers

Compressors, Gas Turbines And Jet Engines MCQ Questions & Answers | Mechanical Engineering

Learn Compressors, Gas Turbines And Jet Engines MCQ questions & answers are available for a Mechanical Engineering students to clear GATE exams, various technical interview, competitive examination, and another entrance exam. Compressors, Gas Turbines And Jet Engines MCQ question is the important chapter for a Mechanical Engineering and GATE students. Page-9 section-1

The mean effective pressure of the compressor is the

A) Actual volume of the air delivered by the compressor when reduced to normal temperature and pressure conditions B) Volume of air delivered by the compressor C) Volume of air sucked by the compressor during its suction stroke D) None of the above

Discuss

Answer & Solution

Answer: Option D

Solution:

The mean effective pressure is a quantity relating to the operation of a reciprocating engine and is a valuable measure of an engine's capacity to do work that is independent of engine displacement.

After-cooler is used to

A) Cool the air B) Decrease the delivery temperature for ease in handling C) Cause moisture and oil vapour to drop out D) Reduce volume

Discuss

Answer & Solution

Answer: Option C

Solution:

After-cooler is used to Cause moisture and oil vapour to drop out

An after-cooler is used to

A) Remove impurities from air B) Reduce volume of air C) Cause moisture and oil vapour to drop out D) Cool the air

Discuss

Answer & Solution

Answer: Option C

Solution:

An after-cooler is used to Cause moisture and oil vapour to drop out

Pick up the correct statement

A) Closed cycle gas turbine is an I.C engine B) Gas turbine uses same working fluid over and over again C) Ideal efficiency of closed cycle gas turbine plant is more than Carnot cycle efficiency D) Thrust in turbojet is produced by nozzle exit gases

Discuss

Answer & Solution

Answer: Option D

Solution:

Thrust in turbojet is produced by nozzle exit gases

Choose the correct statement

A) Gas turbine requires lot of cooling water B) Gas turbine is capable of rapid start up and loading C) Gas turbines has flat efficiency at part loads D) Gas turbines have high standby losses and require lot of maintenance

Discuss

Answer & Solution

Answer: Option B

Solution:

Gas turbine is capable of rapid start up and loading

Pick up the correct statement

A) Large gas turbines use radial inflow turbines B) Gas turbines have their blades similar to steam turbine C) Gas turbine's blade will appear as impulse section at the hub and as a reaction section at tip D) Gas turbines use both air and liquid cooling

Discuss

Answer & Solution

Answer: Option C

Solution:

Gas turbine's blade will appear as impulse section at the hub and as a reaction section at tip

Pick up the correct statement

A) Gas turbine uses low air-fuel ratio to economise on fuel B) Gas turbine uses high air-fuel ratio to reduce outgoing temperature C) Gas turbine uses low air-fuel ratio to develop the high thrust required D) All of the above

Discuss

Answer & Solution

Answer: Option B

Solution:

Gas turbine uses high air-fuel ratio to reduce outgoing temperature

A gas turbine used in air craft should have

A) High h.p. and low weight B) Low weight and small frontal area C) Small frontal area and high h.p. D) High speed and high h.p.

Discuss

Answer & Solution

Answer: Option B

Solution:

A gas turbine used in air craft should have Low weight and small frontal area

The compressor capacity with decrease in suction temperature

A) Increases B) Decreases C) Remain unaffected D) May increase or decrease depending on compressor capacity

Discuss

Answer & Solution

Answer: Option A

Solution:

The compressor capacity with decrease in suction temperature increases

In gas turbines, high thermal efficiency is obtained in

A) Closed cycle B) Open cycle C) Both of the above D) Closed/open depending on other considerations

Discuss

Answer & Solution

Answer: Option A

Solution:

In gas turbines, high thermal efficiency is obtained in closed cycle