Tandem drawing of wires and tubes is necessary because
A. It is not possible to reduce at one stage
B. Annealing is needed between stages
C. Accuracy in dimensions is not possible otherwise
D. Surface finish improves after every drawing stage
Answer: Option B
Solution(By Examveda Team)
Tandem drawing is the drawing force of the process through two dies in tandem was evaluated by being compared with the drawing force of a conventional drawing process.Tandem drawing of wires and tubes is necessary because annealing is needed between stages.
Related Questions on Workshop Technology
The brass and bronze are welded by _________ flame.
A. Neutral
B. Oxidizing
C. Carburising
D. All of these
In TIG arc welding, the welding zone is shielded by an atmosphere of
A. Helium gas
B. Argon gas
C. Either (A) or (B)
D. None of these
In sheet metal blanking, shear is provided on punches and dies so that
A. Press load is reduced
B. Good cut edge is obtained
C. Warping of sheet is minimized
D. Cut blanks is straight
Join The Discussion