The upsetting is a process of
A. Increasing the cross-section of a bar
B. Reducing the cross-section of a bar
C. Joining the two surfaces of metal under pressure after heating
D. Bending of a bar
Answer: Option A
Solution(By Examveda Team)
Upsetting of metals is a deformation process in which a billet is compressed between two dies in a press or a hammer.This operation reduces the height of a part while increasing its diameter. The process is mostly used as an intermediate step in multiple step forging operations
Related Questions on Workshop Technology
The brass and bronze are welded by _________ flame.
A. Neutral
B. Oxidizing
C. Carburising
D. All of these
In TIG arc welding, the welding zone is shielded by an atmosphere of
A. Helium gas
B. Argon gas
C. Either (A) or (B)
D. None of these
In sheet metal blanking, shear is provided on punches and dies so that
A. Press load is reduced
B. Good cut edge is obtained
C. Warping of sheet is minimized
D. Cut blanks is straight
Join The Discussion