Examveda

Which of the following uses ATM as the Data Link layer protocol that's terminated at what's known as the DSLAM?

A. DSL

B. PPPoE

C. Frame Relay

D. Dedicated T1

E. Wireless

Answer: Option A

Solution (By Examveda Team)

ATM is the Data-Link layer protocol that's typically used over the DSL layer 1 connection from the CPE and terminated at what's known as the DSLAM-an ATM switch that contains DSL interface cards, or ATU-Cs.

This Question Belongs to Networking >> Wide Area Networks

Join The Discussion

Related Questions on Wide Area Networks

When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

A. The Frame Relay encapsulation on the physical interface

B. The local DLCI on each subinterface

C. An IP address on the physical interface

D. The subinterface type as point-to-point

E. PAP

View Answer

Which command will display the CHAP authentication process as it occurs between two routers in the network?

A. show chap authentication

B. show interface serial 0

C. debug ppp authentication

D. debug chap authentication

View Answer

The Acme Corporation is implementing dial-up services to enable remote-office employees to connect to the local network. The company uses multiple routed protocols, needs authentication of users connecting to the network, and since some calls will be long distance, needs callback support. Which of the following protocols is the best choice for these remote services?

A. 802.1

B. Frame Relay

C. HDLC

D. PPP

E. PAP

View Answer

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?

A. Router(config-if)# encapsulation frame-relay q933a

B. Router(config-if)# encapsulation frame-relay ansi

C. Router(config-if)# encapsulation frame-relay ietf

D. Router(config-if)# encapsulation frame-relay cisco

View Answer