ExamVeda
Login
Home

When setting up Frame Relay for point-to-point subinterfaces which of the...

This question belongs to Networking Wide Area Networks
Wide Area Networks
?

When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

Answer & Solution
Correct Answer: Option C
It is very important to remember when studying the CCNA exam objectives, and when configuring Frame Relay with point-to-point subinterfaces, that you do not put an IP address on the physical interface.
Examveda
Question posted by Examveda
Community

Join the Discussion

1 Comment
Ali Hussein
Ali Hussein 5 years ago
Draw the Simulink block diagram of separately excited DC motor and check out the system's
response by including the PID controller. Also, you can test your response employing only the Matlab code
without using the Simulink toolbox.
Keep Learning

Related Questions on Wide Area Networks

When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?
A. The Frame Relay encapsulation on the physical interface B. The local DLCI on each subinterface C. An IP address on the physical interface D. The subinterface type as point-to-point E. PAP
Which command will display the CHAP authentication process as it occurs between two routers in the network?
A. show chap authentication B. show interface serial 0 C. debug ppp authentication D. debug chap authentication
The Acme Corporation is implementing dial-up services to enable remote-office employees to connect to the local network. The company uses multiple routed protocols, needs authentication of users connecting to the network, and since some calls will be long distance, needs callback support. Which of the following protocols is the best choice for these remote services?
A. 802.1 B. Frame Relay C. HDLC D. PPP E. PAP
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A. Router(config-if)# encapsulation frame-relay q933a B. Router(config-if)# encapsulation frame-relay ansi C. Router(config-if)# encapsulation frame-relay ietf D. Router(config-if)# encapsulation frame-relay cisco
More Related Questions on Wide Area Networks