Workshop Technology MCQ Questions & Answers | Mechanical Engineering Page-1 section-3

Section 1 Section 2 Section 3

1.
In a _______, the molten metal is poured and allowed to solidify while the mould is revolving.

A. Die casting method

B. Slush casting method

C. Permanent mould casting method

D. Centrifugal casting method

Answer & Solution Discuss in Board Save for Later

2.
A sand employed on the faces of the pattern before moulding, is called

A. Green sand

B. Dry sand

C. Loam sand

D. Parting sand

Answer & Solution Discuss in Board Save for Later

3.
The mode of deformation of the metal during spinning is

A. Bending

B. Stretching

C. Rolling and stretching

D. Bending and stretching

Answer & Solution Discuss in Board Save for Later

4.
The material which can be best cut with oxygen cutting process is

A. Mild steel

B. Brass

C. Copper

D. Aluminium

Answer & Solution Discuss in Board Save for Later

5.
During hot working of metals

A. Porosity of the metal is largely eliminated

B. Grain structure of the metal is refined

C. Mechanical properties are improved due to refinement of grains

D. All of the above

Answer & Solution Discuss in Board Save for Later

6.
The temperature of oxy-hydrogen flame is ________ oxyacetylene flame.

A. Same as

B. Less than

C. More than

D. None of these

Answer & Solution Discuss in Board Save for Later

Workshop Technology MCQ Questions & Answers | Mechanical Engineering

1. In a _______, the molten metal is poured and allowed to solidify while the mould is revolving.

Answer & Solution

2. A sand employed on the faces of the pattern before moulding, is called

Answer & Solution

3. The mode of deformation of the metal during spinning is

Answer & Solution

4. The material which can be best cut with oxygen cutting process is

Answer & Solution

5. During hot working of metals

Answer & Solution

6. The temperature of oxy-hydrogen flame is ________ oxyacetylene flame.

Answer & Solution

Read More Section(Workshop Technology)

1.
In a _______, the molten metal is poured and allowed to solidify while the mould is revolving.

2.
A sand employed on the faces of the pattern before moulding, is called

3.
The mode of deformation of the metal during spinning is

4.
The material which can be best cut with oxygen cutting process is

5.
During hot working of metals

6.
The temperature of oxy-hydrogen flame is ________ oxyacetylene flame.