ExamVeda
Login
Home

A in a boiler is used to put off fire in...

This question belongs to Mechanical Engineering Steam Boilers, Engines, Nozzles And Turbines
Steam Boilers, Engines, Nozzles and Turbines
?

A _________ in a boiler is used to put off fire in the furnace of the boiler when the level of water in the boiler falls to an unsafe limit.

Answer & Solution
Correct Answer: Option B
Let's discuss the solution. Join the discussion
Examveda
Question posted by Examveda
Community

Join the Discussion

5 Comments
Sahil Kamboj
Sahil Kamboj 5 years ago
the aswer is correct i checked
Sahil Kamboj
Sahil Kamboj 5 years ago
isnt its stop valve? i am not sure
Rishi Gupta
Rishi Gupta 6 years ago
Stirling cycle and a Connaught cycle operate between 50 degree and 350 degree Celsius. Their efficiency are
Rishi Gupta
Rishi Gupta 6 years ago
Which one of the following cycle working within same temperature limit has the highest work ratio
Rishi Gupta
Rishi Gupta 6 years ago
D level turbine has a shaft speed of about
Keep Learning

Related Questions on Steam Boilers, Engines, Nozzles and Turbines

The expansion of steam in a nozzle follows
A. Carnot cycle B. Rankine cycle C. Joule cycle D. Stirling cycle
In a uniflow engine
A. Steam enters and exhausts through the same port B. Steam enters at one end and exhausts at the centre C. Steam enters at the centre and exhausts at the other end D. None of the above
The mechanical draught _________ with the amount of smoke.
A. Increases B. Decreases C. Does not effect D. None of these
Gradually increasing temperature of flue gases at inlet to chimney for given steam outputs is an indication of
A. Higher effectiveness of boiler B. High calorific value coal being burnt C. Fouling of heat transfer surfaces D. Raising of steam temperature
More Related Questions on Steam Boilers, Engines, Nozzles and Turbines