ExamVeda
Login
Home
61
In closed circuit grinding as compared to open circuit grinding, the
Discuss
Answer & Solution
Answer: Option A
Solution:
The correct answer is Option A: Specific surface of product is more.
Here's why:
Closed circuit grinding involves a classifier (like a sieve or cyclone) that separates the ground material.
Only the material *larger* than the desired size is sent back for further grinding.
Open circuit grinding, on the other hand, grinds everything in one go without separation.
Think of it like this:
In closed circuit:
Only the coarser particles are re-ground.
This continuous re-grinding of coarse particles ensures a finer product.
Finer product means more surface area per unit mass (specific surface). So, the specific surface is higher.
In open circuit:
Everything is ground together, leading to a wider range of particle sizes.
Here's why the other options are incorrect:
Option B: Product has lesser size uniformity: Closed circuit gives *better* size uniformity because oversized particles are re-ground.
Option C: Production rate at a given limiting size is lower: Closed circuit often has a *higher* production rate at a specific size because it efficiently processes only oversized particles.
Option D: Operation is economical: While the initial investment might be higher, closed-circuit grinding can be more economical in the long run due to *increased efficiency and reduced over-grinding* but it's not the primary benefit directly related to the grinding process itself. The increased specific surface area is the most direct result.
62
In washing type plate and frame filter press, the ratio of washing rate to the final filtrate rate is
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
63
Specific surface area is the surface area of a unit __________ of materials.
Discuss
Answer & Solution
Answer: Option C
No explanation is given for this question. Let's Discuss on Board
64
Colloidal mills are used for __________ grinding.
Discuss
Answer & Solution
Answer: Option D
No explanation is given for this question. Let's Discuss on Board
65
Cyclones are used primarily for separating
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
66
For spheres, the surface shape factor is given by (where, A = area, V = volume, and D = diameter)
Discuss
Answer & Solution
Answer: Option A
No explanation is given for this question. Let's Discuss on Board
67
For a turbine agitated and baffled tank, operating at low Reynold's number (based on impeller diameter), the power number (Np) varies with NRe as
Discuss
Answer & Solution
Answer: Option D
No explanation is given for this question. Let's Discuss on Board
68
The specific cake resistance for incompressible sludges is (where ΔP = pressure drop over cake)
Discuss
Answer & Solution
Answer: Option D
No explanation is given for this question. Let's Discuss on Board
69
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board
70
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
Discuss
Answer & Solution
Answer: Option B
No explanation is given for this question. Let's Discuss on Board