If a single tube pass heat exchanger is converted to two passes; for the same flow rate, the pressure drop per unit length in tube side will __________ times.
A. Increase by 1.8
B. Decrease by 22
C. Increase by 21.6
D. None of these
Answer: Option C
This Question Belongs to Chemical Engineering >> Process Equipment And Plant Design
Join The Discussion
Comments ( 1 )
Related Questions on Process Equipment and Plant Design
Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.
A. $$\frac{1}{8}$$ and $$\frac{1}{{64}}$$
B. $$\frac{1}{{64}}$$ and $$\frac{1}{8}$$
C. $$\frac{1}{2}$$ and 8
D. $$\frac{1}{2}$$ and 5
A. Less than
B. 1.25-1.50 times
C. 2.5 times
D. One-fourth of
Value of Peclet number = 0, is the representative of
A. Laminar flow
B. Complete back mixing
C. Plug flow
D. Eddy diffusivity = 0
Solution plz