If you wanted administrators to see a message when logging into the router, which command would you use?

Which of the following commands sets the secret password to Cisco?

A. enable secret password Cisco

B. enable secret cisco

C. enable secret Cisco

D. enable password Cisco

You type the following command into the router and receive the following output:

Router#show serial 0/0
        ^
% Invalid input detected at '^' marker.

A. You need to be in privileged mode.

B. You cannot have a space between serial and 0/0.

C. The router does not have a serial0/0 interface.

D. Part of the command is missing.

Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface

A. 1, 2 and 4

B. 2, 3 and 5

C. 3 and 4 only

D. None of the above

You type show running-config and get this output:

[output cut]
Line console 0
    Exec-timeout 1 35
    Password BIXPASSWD
    Login
[output cut]

A. If no command has been typed in 35 seconds, the console connection will be closed.

B. If no router activity has been detected in 1 hour and 35 minutes, the console will be locked out.

C. If no commands have been typed in 1 minute and 35 seconds, the console connection will be closed.

D. If you're connected to the router by a Telnet connection, input must be detected within 1 minute and 35 seconds or the connection will be closed.