In unilateral system of tolerance, the tolerance is allowed on
A. Both sides of the actual size
B. One side of the actual size
C. One side of the nominal size
D. Both sides of the nominal size
Answer: Option C
This Question Belongs to Mechanical Engineering >> Machine Design
A cotter joint is used to connect two __________ rods.
A. Co-axial
B. Perpendicular
C. Parallel
D. None of these
The rated life of a bearing varies
A. Directly as load
B. Inversely as square of load
C. Inversely as cube of load
D. Inversely as fourth power of load
The bending stress in a curved beam is
A. Zero at the centroidal axis
B. Zero at the point other than centroidal axis
C. Maximum at the neutral axis
D. None of these
The centre to centre distance between two consecutive rivets in a row, is called
A. Margin
B. Pitch
C. Back pitch
D. Diagonal pitch
Join The Discussion