LMTD correction factor is used in heat exchanger design for
A. Double pipe heat exchanger
B. Multipass shell and tube heat exchanger
C. Fouling fluids
D. Counter flow of hot and cold fluids
Answer: Option B
Related Questions on Process Equipment and Plant Design
Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.
A. $$\frac{1}{8}$$ and $$\frac{1}{{64}}$$
B. $$\frac{1}{{64}}$$ and $$\frac{1}{8}$$
C. $$\frac{1}{2}$$ and 8
D. $$\frac{1}{2}$$ and 5
A. Less than
B. 1.25-1.50 times
C. 2.5 times
D. One-fourth of
Value of Peclet number = 0, is the representative of
A. Laminar flow
B. Complete back mixing
C. Plug flow
D. Eddy diffusivity = 0
Join The Discussion