Pick out the wrong statement pertaining to a shell and tube heat exchanger.
A. The minimum value of baffle spacing is 50 mm
B. The maximum value of baffle spacing is equal to the I.D. of the shell
C. The maximum unsupported tube span is generally about 75 times tube diameter, but is reduced to about 60 times for aluminium, copper & alloys of these
D. Disk and doughnut baffle is the most commonly used baffle
Answer: Option D
This Question Belongs to Chemical Engineering >> Process Equipment And Plant Design
Width and depth of grooves in the tube sheet holes normally are __________ inch respectively.
A. $$\frac{1}{8}$$ and $$\frac{1}{{64}}$$
B. $$\frac{1}{{64}}$$ and $$\frac{1}{8}$$
C. $$\frac{1}{2}$$ and 8
D. $$\frac{1}{2}$$ and 5
A. Less than
B. 1.25-1.50 times
C. 2.5 times
D. One-fourth of
Value of Peclet number = 0, is the representative of
A. Laminar flow
B. Complete back mixing
C. Plug flow
D. Eddy diffusivity = 0
Join The Discussion