The flank of the tooth is the
A. Surface of the top of the tooth
B. Surface of the tooth above the pitch surface
C. Width of the tooth measured along the pitch circle
D. Surface of the tooth below the pitch surface
Answer: Option D
This Question Belongs to Mechanical Engineering >> Machine Design
A cotter joint is used to connect two __________ rods.
A. Co-axial
B. Perpendicular
C. Parallel
D. None of these
The rated life of a bearing varies
A. Directly as load
B. Inversely as square of load
C. Inversely as cube of load
D. Inversely as fourth power of load
The bending stress in a curved beam is
A. Zero at the centroidal axis
B. Zero at the point other than centroidal axis
C. Maximum at the neutral axis
D. None of these
The centre to centre distance between two consecutive rivets in a row, is called
A. Margin
B. Pitch
C. Back pitch
D. Diagonal pitch
Join The Discussion