ExamVeda
Login
Home

You copy a configuration from a network host to a router's...

This question belongs to Networking Managing A Cisco Internetwork
Managing a Cisco Internetwork
?

You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?

Answer & Solution
Correct Answer: Option C
Since the configuration looks correct, you probably didn't screw up the copy job. However, when you perform a copy from a network host to a router, the interfaces are automatically shut down and need to be manually enabled with the no shutdown command.
Examveda
Question posted by Examveda
Community

Join the Discussion

No comments yet Be the first to discuss this question.
Keep Learning

Related Questions on Managing a Cisco Internetwork

You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful?
1. TFTP server software must be running on the router.
2. TFTP server software must be running on your laptop.
3. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable.
4. The laptop must be on the same subnet as the router's Ethernet interface.
5. The copy flash tftp command must be supplied the IP address of the laptop.
A. 1, 3 and 4 B. 2, 4 and 5 C. 3 and 5 only D. 5 only
What information is displayed by the show hosts command?
1. Temporary DNS entries
2. The names of the routers created using the hostname command
3. The IP addresses of workstations allowed to access the router
4. Permanent name-to-address mappings created using the ip host command
5. The length of time a host has been connected to the router via Telnet
A. 1, 2 and 3 B. 1 and 4 C. 3, 4, and 5 D. All of the above
You are unsuccessful in telnetting into a remote device. What could the problem be?
1. IP addresses are incorrect.
2. Access control list is filtering Telnet.
3. There is a defective serial cable.
4. The VTY password is missing.
A. 1 only B. 3 only C. 2 and 4 only D. All of the above
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
A. 1 ,2 and 4 B. 2 and 5 C. 3 and 5 D. None of the above
More Related Questions on Managing a Cisco Internetwork