Allowance in limits and fits refers to
A. Maximum clearance between shaft and hole
B. Minimum clearance between shaft and hole
C. Difference between maximum and minimum sizes of hole
D. Difference between maximum and minimum sizes of shaft
Answer: Option B
This Question Belongs to Mechanical Engineering >> Manufacturing And Production Technology
Join The Discussion
Comments ( 3 )
Related Questions on Manufacturing and Production Technology
The carbide tools operating at very low cutting speeds (below 30 m/min)
A. Reduces tool life
B. Increases tool life
C. Have no effect on tool life
D. Spoils the work piece
The type of reamer used for reaming operation in a blind hole, is
A. Straight fluted reamer
B. Left hand spiral fluted reamer
C. Right hand spiral fluted reamer
D. Any one of these
High speed steel tools retain their hardness up to a temperature of
A. 250°C
B. 350°C
C. 500°C
D. 900°C
B is correct
B is correct...
B answer