Steering and Suspension System MCQ Questions & Answers

Steering and Suspension System MCQ Questions & Answers | Automobile Engineering

Learn and Practice Steering and Suspension System MCQ Questions & Answers are Available for Automobile Engineering Students to Clear GATE Exams, Technical Interviews, Competitive Examinations, and Other Entrance Exams. The Steering and Suspension System Chapter is Especially Important for Automobile Engineering and GATE Students. Page-3 section-1

The length of the steering arm or drop arm varies between . . . . . . . . in case of motor cars.

A) 10.5 to 10.8 B) 12.5 to 20.0 C) 20.0 to 25.0 D) None

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The value of king pin inclination for dodge is-

A) 8° B) 7° C) 3° D) 1°

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

Which the following type of spring is most commonly used for suspension in heavy vehicles?

A) Coil spring B) Semi elliptic leaf spring C) Quarter elliptic leaf spring D) Plastic spring

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

Which of the following is the function of steering system?

A) In helps in swinging the wheels to the left or right B) It helps in turning the vehicle at the will of the driver C) It provides directional stability D) All are correct

Discuss

Answer & Solution

Answer: Option D

No explanation is given for this question. Let's Discuss on Board

Hard steering is due to

A) Low tyre pressure B) High speed of vehicle C) Worn out bearing of front wheels D) Stub axle bending

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

The steering wheel diameter of the standard-10 car is-

A) 39 cm B) 93 cm C) 22 cm D) None

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

The tilting of front wheel away from the vertical is known as

A) Castor B) Camber C) Toe-in D) Toe-out

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

The name of the component that connects the rack to the steering knuckles is

A) Tie rod B) Sector gear C) Pivot D) Spline

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

The correct steering formula is
where $$\phi $$ and $$\theta $$ = Angle made by outside and inside front wheels respectively with the axle at their extreme positions;
b = Wheel base, and c = Distance between the pivot points of the front axle.

A) $$\cot \phi - \cot \theta = {c \over b}$$ B) $$\cot \theta - \cot \phi = {b \over c}$$ C) $$2\cot \phi = l\cot \theta $$ D) $$2\cot \theta = l\cot \phi $$

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

Caster action on front wheel of a vehicle will

A) Make it easier for the driver to take corners B) Help reduce the load on the king pin C) Automatically achieve the straight wheel position D) None of the above

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board