Wheels and Tires MCQ Questions & Answers

91

Tread wear indicator is located:

A) On the tyre, where the tread meets the side wall B) On the dashboard of the vehicle C) At the wheel alignment shops D) On the front bumper of the vehicle

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

92

That part of the rim which provides lateral support to the tyre is called-

A) Well B) Gutter C) Flange D) None of these

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

93

To perform a good function the wheel must be-

A) Strong enough B) Able to grip the road surface C) Both are correct D) None of the above

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

94

The disadvantage of radial ply tyre as compared to cross ply tyre is

A) Uncomfortable ride at low speeds B) Uncomfortable ride at high speeds C) Higher cornering power D) Lower rolling resistance

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

95

The main function of the tread pattern on tyre is that

A) The tread grooves pass air between the tyre and road surface, thereby preventing tyre from overheating B) The crests between the tread grooves absorb road noise C) In wet conditions, the tread grooves expel water that is drawn between the tyre and road surface D) The tread pattern protects the tyre's inner carcass from small stones and pieces of glass

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

96

A slip joint permits changes in

A) Wheel base B) Wheel track C) Wheel alignment D) None of the above

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

97

In a wheel specification $$13 \times 5{1 \over 2}B,$$ the alphabet B represents the

A) Width of wheel B) Rim type C) Diameter of wheel D) Offset

Discuss

Answer & Solution

Answer: Option B

No explanation is given for this question. Let's Discuss on Board

98

The distance between the centre lines of the rims to provide the required clearance between tyres is called-

A) Dual spacing B) Zeroset wheel C) Rim D) None of these

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

99

When a tyre's wear indicator becomes visible, how much tread depth remains?

A) 6 mm B) 2.6 mm C) 1.6 mm D) 0.6 mm

Discuss

Answer & Solution

Answer: Option C

No explanation is given for this question. Let's Discuss on Board

100

. . . . . . . . is a bag of rubber in which air is filled through valve.

A) Tube B) Cord plies C) Well D) Tread

Discuss

Answer & Solution

Answer: Option A

No explanation is given for this question. Let's Discuss on Board

Wheels and Tires MCQ Questions & Answers | Automobile Engineering