91. Rate of chemical reaction is not much affected, if the reactants are in __________ form.
92. Resistance of an electrical conductor is proportional to its (where, L = length and A = cross-sectional area of the conductor)
93. Out of the following the refractive index is the highest for
94. Compressed dry air is used as the cutting fluid, while machining
95. The taper provided on pattern for its easy & clean withdrawal from the mould is termed as the __________ allowance.
96. Cold working of a material results in increase in hardness, which is termed as the __________ hardening.
97. The increase in hardness of metal due to its cold working is termed as the __________ hardening.
98. Dryness factor of steam is defined as the ratio of the mass of vapor in the mixture to the mass of the mixture. Dryness factor of steam is measured by a __________ calorimeter.
99. Pressure exerted by a liquid depends upon its
100. Scab is a defect developed during __________ of metals.
Read More Section(Chemical Engineering Basics)
Each Section contains maximum 100 MCQs question on Chemical Engineering Basics. To get more questions visit other sections.
- Chemical Engineering Basics - Section 1
- Chemical Engineering Basics - Section 2
- Chemical Engineering Basics - Section 3
- Chemical Engineering Basics - Section 5
- Chemical Engineering Basics - Section 6
- Chemical Engineering Basics - Section 7
- Chemical Engineering Basics - Section 8
- Chemical Engineering Basics - Section 9
- Chemical Engineering Basics - Section 10
- Chemical Engineering Basics - Section 11
- Chemical Engineering Basics - Section 12
- Chemical Engineering Basics - Section 13