61. Consider the following statements:
1. Speed of operation of MOSFET is more than the speed of operation of SCR.
2. SCRs have lower power loss than MOSFETs.
3. The current in conducting state can easily be controlled through the gate in SCR.
4. MOSFET is not a current-triggered device.
The correct statements are:
1. Speed of operation of MOSFET is more than the speed of operation of SCR.
2. SCRs have lower power loss than MOSFETs.
3. The current in conducting state can easily be controlled through the gate in SCR.
4. MOSFET is not a current-triggered device.
The correct statements are:
62. Following are the applications of a Buck and Boost converters respectively
1. Regulated DC power supplies
2. Regenerative braking of DC motors
3. DC motor speed control
1. Regulated DC power supplies
2. Regenerative braking of DC motors
3. DC motor speed control
63. SCR can be used in
64. The primary function of a phase inverter is to change the phase of a signal by
65. Match List-I with List-II and select the correct answer using the options given below:
List-I (Power Device)
List-II (Maximum operation frequency)
a. Bipolar transistors
1. 1 MHz
b. Power MOSFET
2. 100 kHz
c. Silicon controlled rectifier
3. 1 kHz
d. Insulated gate bipolar transistor
4. 10 kHz
| List-I (Power Device) | List-II (Maximum operation frequency) |
| a. Bipolar transistors | 1. 1 MHz |
| b. Power MOSFET | 2. 100 kHz |
| c. Silicon controlled rectifier | 3. 1 kHz |
| d. Insulated gate bipolar transistor | 4. 10 kHz |
Read More Section(Power Electronics)
Each Section contains maximum 100 MCQs question on Power Electronics. To get more questions visit other sections.