If you want to have more than one Telnet session open...

Home / Networking / Managing A Cisco Internetwork / Question

Examveda

If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?

A. Tab+Spacebar

B. Ctrl+X, then 6

C. Ctrl+Shift+X, then 6

D. Ctrl+Shift+6, then X

Answer: Option D

Solution (By Examveda Team)

To keep open one or more Telnet sessions, use the Ctrl+Shift+6 and then X keystroke combination.

This Question Belongs to Networking >> Managing A Cisco Internetwork

Join The Discussion

Related Questions on Managing a Cisco Internetwork

You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful?
1. TFTP server software must be running on the router.
2. TFTP server software must be running on your laptop.
3. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable.
4. The laptop must be on the same subnet as the router's Ethernet interface.
5. The copy flash tftp command must be supplied the IP address of the laptop.

A. 1, 3 and 4

B. 2, 4 and 5

C. 3 and 5 only

D. 5 only

View Answer

View Answer

What information is displayed by the show hosts command?
1. Temporary DNS entries
2. The names of the routers created using the hostname command
3. The IP addresses of workstations allowed to access the router
4. Permanent name-to-address mappings created using the ip host command
5. The length of time a host has been connected to the router via Telnet

A. 1, 2 and 3

B. 1 and 4

C. 3, 4, and 5

D. All of the above

View Answer

View Answer

You are unsuccessful in telnetting into a remote device. What could the problem be?
1. IP addresses are incorrect.
2. Access control list is filtering Telnet.
3. There is a defective serial cable.
4. The VTY password is missing.

A. 1 only

B. 3 only

C. 2 and 4 only

D. All of the above

View Answer

View Answer

Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups

A. 1 ,2 and 4

B. 2 and 5

C. 3 and 5

D. None of the above

View Answer

View Answer

More Related Questions on Managing a Cisco Internetwork