ExamVeda
Login
Home

In American Standard Association (ASA) system if the tool nomenclature is...

This question belongs to Mechanical Engineering Manufacturing And Production Technology
Manufacturing and Production Technology
?

In American Standard Association (ASA) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be

Answer & Solution
Correct Answer: Option B
According To ASA System the tool nomenclature is to be followed by this procedure : Back rake angle, Side rake angle, Front or end clearance or relief angle, Side clearance angle or relief angle, End cutting edge angle, Side cutting edge angle, Nose radius. From the System Side rake angle is 6°
Examveda
Question posted by Examveda
Community

Join the Discussion

No comments yet Be the first to discuss this question.
Keep Learning

Related Questions on Manufacturing and Production Technology

The carbide tools operating at very low cutting speeds (below 30 m/min)
A. Reduces tool life B. Increases tool life C. Have no effect on tool life D. Spoils the work piece
The type of reamer used for reaming operation in a blind hole, is
A. Straight fluted reamer B. Left hand spiral fluted reamer C. Right hand spiral fluted reamer D. Any one of these
Stellite preserves hardness up to a temperature of
A. 350°C B. 500°C C. 900°C D. 1100°C
High speed steel tools retain their hardness up to a temperature of
A. 250°C B. 350°C C. 500°C D. 900°C
More Related Questions on Manufacturing and Production Technology