Often earing defects are found during deep drawing operation, because the
A. surface finish of the sheet is poor
B. sheet material has been given substantial spring back
C. starting sheet has planer anisotropy due to its texture
D. starting sheet has normal anisotropy due to its texture
Answer: Option C
This Question Belongs to Metallurgical Engineering >> Mechanical Metallurgy
Related Questions on Mechanical Metallurgy
In a tensile test of ductile material, necking starts at
A. lower yield stress
B. upper yield stress
C. ultimate tensile strength
D. just before fracture
A. $$2 + \frac{{\sigma 3}}{2}$$
B. $$4 + \frac{{\sigma 3}}{5}$$
C. $$5 + \frac{{\sigma 3}}{2}$$
D. $$5 + \frac{{\sigma 3}}{3}$$
A. P-1, Q-2, R-3
B. P-4, Q-3, R-1
C. P-3, Q-1, R-4
D. P-2, Q-1, R-3
A. the outer edges of the rod
B. $$\frac{r}{3}$$ from the centre
C. $$\frac{r}{2}$$ from the centre
D. the centre
Join The Discussion