The distributor serves the following purposes in the ignition system
A. It operates break and make mechanism
B. It distributes high tension current to spark plug at correct time
C. Both A and B
D. None of the above
Answer: Option C
This Question Belongs to Automobile Engineering >> Ignition System
Spark plug gaps are required in the range of
A. 0.02 to 0.6 mm
B. 0.45 to 1.00 mm
C. 0.90 to 2.00 mm
D. 1.00 to 1.30 mm
A. It is the time for which the contact breaker points remain closed
B. It is the time for which the contact breaker points remain open
C. The time during which inlet and exhaust valves open
D. The time during which inlet and exhaust valves close
Preignition can be caused due to presence of . . . . . . . .
A. Excess lubricants in cylinder
B. Gum in fuel
C. Over-heated spark plug
D. Higher volume of air in air fuel mixture
A signal generator in transistorized ignition system consist of
A. Ignition coil, permanent magnet and electronic control unit
B. A signal rotor, permanent magnet and electronic control unit
C. A signal rotor, a pick up coil and electronic control unit
D. A signal rotor, a pick up coil and a permanent magnet
Join The Discussion