The most serious manufacturing defect from fracture toughness point of view is
A. surface roughness
B. pore
C. spherical inclusion
D. crack
Answer: Option D
This Question Belongs to Metallurgical Engineering >> Mechanical Metallurgy
Related Questions on Mechanical Metallurgy
In a tensile test of ductile material, necking starts at
A. lower yield stress
B. upper yield stress
C. ultimate tensile strength
D. just before fracture
A. $$2 + \frac{{\sigma 3}}{2}$$
B. $$4 + \frac{{\sigma 3}}{5}$$
C. $$5 + \frac{{\sigma 3}}{2}$$
D. $$5 + \frac{{\sigma 3}}{3}$$
A. P-1, Q-2, R-3
B. P-4, Q-3, R-1
C. P-3, Q-1, R-4
D. P-2, Q-1, R-3
A. the outer edges of the rod
B. $$\frac{r}{3}$$ from the centre
C. $$\frac{r}{2}$$ from the centre
D. the centre
Join The Discussion