The number of cross point needed for 10 lines in a cross point switch which is full duplex in nature and there are no self connection is
A. 100
B. 45
C. 50
D. 90
Answer: Option B
Solution(By Examveda Team)
As all lines are full-duplex and there are no self connections, only the cross points above the diagonals are needed. Hence formula for the number of cross points required is n(n-1)/2.Join The Discussion
Comments ( 2 )
Related Questions on Networking Miscellaneous
A. Agreements on how communication components and DTE
B. Logical communication channels used for transferri
C. Physical communication channels used for transferr
D. None of the above
A. Simplex
B. Four wire circuit
C. Full Duplex
D. Half Duplex
Error detection at the data link level is achieved by
A. Bit Stuffing
B. Cyclic Redundancy Code
C. Hamming Code
D. Equalization
Which of the following is a wrong example of network layer?
A. Internet Protocol (IP) - ARPANET
B. X.25 Packet Level Protocol (PLP)-ISO
C. Source routing and domain naming-USENet
D. X.25 level 2-ISO
n(n-1)/2
n = 10
then
10(10-1)/2
=10*9/2
=90/2
=45
Thanksss